7440 50W-8Ohm Resistor LED Error Warning Canceller Fix Hyper Flash For LED Turn Signal Lights
Tax included.
Description:
This auction features all new full 50W-8Ohm 7440 T20 hyper flash fix error free wiring harness for turn signal lights.
This Error Free wiring harness will ensure no annoying rapid flashing nor error when installing 7440 7440A 992 T20 single filament
By using this, you will no longer need to tap any resistors which will cut and damage your stock harness.
LED bulbs for the turn signal lights.
7440/992/T20 single filament lamp connector
Male and female connector included
Pre-Wired for Plug and Play. No need to modify the stock wires at all
16 Gauge wire, high efficient copper wiring
Specification:
Type: 1156/7506/P21W
Voltage: 12V
50W 5Ohm
Wire: 22CM
Material: Aluminum Alloy
Installation:
Easy DIY installation: just simply connect the wires of the socket connector to any 12V power source
and insert a correct size light bulb. All connectors have a positive and a negative wires.
If the bulb doesn't light up after plug in, please swap the bulb’s +/- sides and reinsert again.
Please make sure the power is OFF during installation.
Please check the pictures above to ensure proper fitting
Note:
Package include only 1 pcs of resistor. We recommend that customer buy 2Pcs for left and right side.
Package Included:
1 X 1156 50W 8Ohm Resistor
This auction features all new full 50W-8Ohm 7440 T20 hyper flash fix error free wiring harness for turn signal lights.
This Error Free wiring harness will ensure no annoying rapid flashing nor error when installing 7440 7440A 992 T20 single filament
By using this, you will no longer need to tap any resistors which will cut and damage your stock harness.
LED bulbs for the turn signal lights.
7440/992/T20 single filament lamp connector
Male and female connector included
Pre-Wired for Plug and Play. No need to modify the stock wires at all
16 Gauge wire, high efficient copper wiring
Specification:
Type: 1156/7506/P21W
Voltage: 12V
50W 5Ohm
Wire: 22CM
Material: Aluminum Alloy
Installation:
Easy DIY installation: just simply connect the wires of the socket connector to any 12V power source
and insert a correct size light bulb. All connectors have a positive and a negative wires.
If the bulb doesn't light up after plug in, please swap the bulb’s +/- sides and reinsert again.
Please make sure the power is OFF during installation.
Please check the pictures above to ensure proper fitting
Note:
Package include only 1 pcs of resistor. We recommend that customer buy 2Pcs for left and right side.
Package Included:
1 X 1156 50W 8Ohm Resistor